1) Take each of the 10" lengths of Beading Wire and thread one Crimp Tube onto each. Take each of the Beading Wires through one of the connector loops on one side of the Clasp. Take the wire around and back through the Crimp Tube. Pull the wires so that they're even with one another and are fairly close to the connector loops without resricting movement of the wire. Flatten the Crimp Tubes with your Chain Nose Pliers, and cut off the excess wire with your Side Cutters.

2) Start your beadwork.

** Repeat #2 five more times and end the beadwork with attaching the last Rondelle Bar onto both lengths of wire. **

3) Thread the last two Crimp Tubes onto each wire and then take the wires around and through the connector loops on the other side of the Clasp. (Disconnect the clasp if necessary) Take the wires around and back through the Crimp Tubes. Pull so that the slack is taken out of the bracelet and the Crimp Tubes are as close as they can get to the connector loops without restricting movement. Flatten the Crimp Tubes with your Chain Nose Pliers and cut the excess wire off with your Side Cutters.

Quantity of Items Needed
7 Swarovski Spacer Bar 10x4mm Crystal Sterling Plated (AR0200)
4 Crimp Tube Seamless 2x2mm Sterling Silver (BD315)
2 10" Lengths of Beadalon Wire .015" 15ft Silver Plated 19 Strand (BW215)
1 Two Strand Plunger Clasp 15x12mm Sterling Silver (CL725)
24 Swarovski Crystal Pearls 5810 4mm Light Grey (PR4206)
24 Swarovski Crystal Pearls 5810 6mm Black (PR6209)
6 Swarovski Round 2-Hole Setting 6mm Black Diamond Sterling Silver (PS6330)